Dirty Electricity Filter

$54.99 $49.99

What are dirty electricity filters and why do I need them?

Dirty electricity filters, are in my opinion essential in every modern home.  It’s just a question of how many dirty electricity filters you should purchase. Not if you need them or not.

Dirty electricity is a result of interference on the line.  It’s a bit like the old analogue telephone lines that used to get a fuzz on them.

In simple terms the interruption of the electrical supply by modern appliances creates a vibration or radio frequency that transmits emf into the environment around the wiring.  It’s a subtle but potentially dangerous pollution and there is much evidence of harm around high levels.

Modern Home EMF

Modern homes are full of appliances that create dirty electricity.  It happens as a result of interruption of the electrical sine wave via appliances that contain chips or power converters.  In other words almost every modern appliance you can switch on or off in your home.

Dirty Electricity mitigation.

The simplest thing to do is hire one of our rental dirty electricity monitors.

Or if you order 8 dirty electricity filters or more you can borrow a monitor for free. Once it arrives take readings and simply plug in filters around the house until you reach the safe levels covered in the dirty electricity monitor instructions.

A typical three bed home would normally require around 6-10 dirty electricity filters.

What Makes Us Different?

Dirty electricity (DE), also known as dirty mains, dirty power, or electrical pollution, is a term that describes the problem of electromagnetic noise on the mains wiring of a house. DE occupies a part of the spectrum in-between the power frequency fields created by powerlines and substations, and the microwaves produced by mobile phone masts and other wireless devices.

Dirty Electricity can travel into your house on the local electricity supply and it will also be generated by some devices in your home. In the UK, the incoming supply is normally quite clean so the majority of DE is generated by internal devices, though large blocks of flats and similar multi-occupancy living spaces can have a lot of shared DE sources. Common large DE contributors include induction cooker hobs, dimmer switches, televisions, fluorescent light bulbs (including CFLs, or energy efficient bulbs) and computers. Any modern device that has a “switched mode power supply” will create some DE. Solar panel inverters that generate the 230 volts to feed into the electricity supply usually generate a large quantity of dirty electricity.

Many links have been published associating Dirty Electricity with a wide variety of negative health effects, including cancer, asthma, chronic fatigue syndrome, diabetes, ADD, autism and a number of neurological disorders.

You should first try to work out what is causing the DE on your wiring, to determine the best way to reduce/remove it.

The EMFields DE filters will reduce the level of DE when plugged in to the same circuit that you’ve tested the levels in. To use the DE filter, you simply plug it in and switch it on – ideally as close as possible to the item that is causing the DE. Check the reading on the deTekta – you’ll see it has dropped and the percentage that it has dropped by. For DE coming into the home from solar panels or from the incoming electricity supply, it is important to place the filters as close as possible to the consumer unit (fusebox) and electricity meter.

It is very important to suppress the DE as close as possible to its source or it will flow backwards and forwards on the house wiring between the source device and the DE2 filter(s). You may decide to replace some devices with similar ones that produce less DE. Low energy CFL lamps are a good example – some produce lots of DE and some relatively little. Generally LED lamps produce less DE, though incandescent lamps produce virtually none and many electrically sensitive people need to only use incandescent bulbs – “rough service” incandescent bulbs up to 100W are still legally available in some shops (not supermarkets!) and via the internet. Similarly, some dimmer switches produces masses of switching noise and some relatively little – but if you are ES then simple switches are better as they do not produce DE.

What is Dirty Electricity?

DE kitDirty electricity (DE), also known as dirty mains, dirty power, or electrical pollution, is a term that describes the problem of electromagnetic noise being on the mains wiring of a house, when it isn’t supposed to be. Basically, your electrical supply is supposed to have just a 50 Hz sine wave on it, but this is rarely the case. There are almost always significant 2nd and 3rd harmonics (100 and 150 Hz in Europe, 120 and 180 Hz in USA), but these are not thought to be any more harmful than the pure sine wave.

DE consists of high frequency “electrical noise” of 1000 Hz (1 kHz) and upwards that has become superimposed on your wires. It is mostly from devices with “switched-mode power supplies”, but includes short sharp transient spikes from inductive loads like motors being switched on and off. Most of the published work on this uses the Stetzer Microsurge meter which measures noise between about 2 kHz and 120 kHz, however the DE noise extends up into the MHz region – our DeTekta meter readings do include these higher frequencies.

Dirty Electricity can travel into your house on the local electricity supply, or it can be generated by devices in your home. In the UK, the incoming supply is normally quite clean, so the majority of DE is generated by internal devices, though large blocks of flats and similar multi-occupancy living spaces can have a lot of shared DE sources.

dLAN network adapters also put RF signals on your mains wiring and it is good to switch them off at night. The levels in the house rooms are vanishingly tiny when compared with wLAN / WiFi signals, however they may still affect electrosensitive people. dLANs use radio-frequencies above 150 kHz that go up to several tens of megahertz (MHz) and are carried equally on all the wires. These are are not detected by Dirty Electricity meters. High speed/bandwidth (500 Mbps and faster) dLANs produce electrical RF noise up into the 100s of MHz.

Common large contributors to DE include solar panel inverters, induction cooker hobs, dimmer switches, televisions, fluorescent light bulbs (including CFLs, or energy efficient bulbs) and computers. Any device that has a “switched mode power supply” will naturally create DE, but it’s hard to tell exactly which devices do have them and which ones don’t without switching them on and off. Most modern, energy efficient, electronic devices now have them. Older, non-electronic devices such as lamps, ovens, or devices that run on motors, don’t normally create much DE.

We must note that whilst large amounts of DE noise is undoubtedly placed on the mains cable, the electromagnetic fields it causes in the rooms in your house to emit are very low. However, despite our lack of understanding of the mechanisms, there is a significant body of published anecdotal and scientific evidence to support the correlation between DE and various negative health effects.

Many links have been made associating Dirty Electricity with a wide variety of negative health effects, including cancer, asthma, chronic fatigue syndrome, diabetes, ADD, autism and a number of neurological disorders.

Reviews

There are no reviews yet.

Be the first to review “Dirty Electricity Filter”